The QIDI box isn’t ready for prime time.
Tom’s Hardware Verdict
The QIDI Q2 is a fine 3D printer that performed exceptionally well on high temperature filaments. However, the long awaited multimaterial box was a disappointment that failed repeatedly.
$499 at Amazon Check Walmart
Pros
- +
Fast Core XY
- +
Bimetal hardened steel nozzle
- +
Heated chamber with multi-sensor temperature control
- +
Fully Enclosed with activated carbon filtration
- +
QIDI Box doubles as a filament drier
- +
QIDI Box can dry while printing
- +
MET and IECEE CB Product Safety Certification
Cons
- –
QIDI Box not ready
- –
Tight bend In PTFE path to extruder requires DIY riser
- –
Touch Screen interferes with door
Best picks for you
- The Best 3D Printers for Home, Workshop or Business in 2025
- The Best 3D Printers for Kids and Teens 2025
- Best Build Plates for 3D Printers
Why you can trust Tom’s Hardware Our expert reviewers spend hours testing and comparing products and services so you can choose the best for you. Find out more about how we test.
The QIDI Q2 is a great, mid-sized 3D printer that really shines when printing high-temperature filaments. If you’re looking for a single-color printer for engineering filaments with a smaller footprint than the previous QIDI Plus4, then this is what you’re looking for.
Sadly, the QIDI Q2 also comes as a combo with a color multimaterial “QIDI Box” that I simply could not get to work correctly. With all the attention to detail, it is inexplicable that QIDI missed the fact that there was an insurmountable amount of friction in the filament path between the QIDI Box and the printer’s extruder.
After horrible initial prints, I pulled a Bowden tube out of the back of the QIDI Box and tried to push filament to the extruder by hand. The amount of drag on the filament was preposterous. The filament hub was way too tight, and the 90-degree bend in the Bowden tube into the extruder was another choke point. I printed a riser (suggested by QIDI itself) to lift the lid and give the Bowden tube a more gentle bend into the extruder, and printed a guide to straighten the filament path into the hub. This allowed the Box to feed ONE filament into the machine, but not four.
Color swaps are too inconsistent to count on at this point. I did reach out to QIDI and was told that the Box I received was an early unit, and they are working on these issues. At the time of this review, the QIDI Box is a great filament dryer, but not much else.